Panasonic TC-1400Z - Page 7

[
Remote Control Operation (Remote control model only)
(Refer to diagram on page 2.)
The Remote control can only be used when the
“Power” Switch on TV set is in the ON position.
(9) P ower (Stand-by) Button
Push this button to turn the TV set off.
(The Stand-by Indicator will light up.)
Push it again to turn the TV set on.
Note:
Do not leave the TV set in the stand-by
condition for a long period of time.
It is better to switch it off when you are
away for an extended period of time.
(10) Direct Programme Selection Buttons
Push one of the 12 Programme Selection
Buttons, to select one of the programme
numbers 1 ~ 12 directly.
The programme numbers 13 ~ 30 can be
selected with the Programme Number Up
“ A ” or Down “ V ’’ Button.
(11) Programme Number Up and Down
Buttons
Push the Programme Number Up “A”
Button to select the higher programmes.
Push the Programme Number Down “V”
Button to select the lower programmes.
(12) Volume Up “-H” and Down ” Buttons
Push the Volume Up “-I-” Button to in¬
crease the sound level.
Push the Volume Down ” Button to
decrease the sound level.
(13) Sound Mute Button
Push this button once to mute the sound.
The on-screen display of the previous
sound level will appear in red.
Push the button once again or push the
Volume “Up” or “Down” Button to restore
the previous sound level.
(14) Normalization Button
When this button is pushed, the colour and
brightness are automatically reset to the
factory-preset levels.
(15) Colour Up and Down Buttons
Push the Colour Up “-I-" Button to increase
the colour (saturation) level.
Push the Colour Down Button to
decrease the colour (saturation) level.
(16) Brightness Up and Down Buttons
Push the Brightness Up “-I-” Button to
increase the brightness level.
Push the Brightness Down ” Button to
decrease the brightness level.
(17) Recall Button
Push the Recall Button to activate the on¬
screen display.
The current Programme Number will be
displayed.
(18) Off-Timer Button
The TV set can be preset to switch off after
a fixed period. Pushing the Off Timer
button will set the TV for 30 minutes, push
again to set 60 minutes and again for 90
minutes.
Pushing the button once more will return
the Off Timer to zero.
30 « ED 3D # DD
When a time for switch off has been set,
the pre-set time will be displayed on the
screen in the bottom right hand corner until
the preset time expires or is cancelled.
Off Timer can be cancelled in the following
ways:
1. Set the Off Timer condition to “00”
using the Off Timer button.
Note:
This only cancels the Off Timer com¬
mand but does not switch off the TV set.
2. Turning the TV set off, using the
“Power” button on the Remote Control
or the “Power” switch on the TV set.
- 6 -