Panasonic TC-1400Z - General Operation

General Operation
(Refer to diagram on page 2.)
(1) Programme Number Up and Down
Buttons
Push the Programme Number Up “A” Button to
select the higher programme numbers.
Push the Programme Number Down “ V ”
Button to select the lower programme numbers.
(2) Volume Up “+” and Down ” Buttons
Push the Volume Up “+” Button to increase
the sound level.
Push the Volume Down ” Button to
decrease the sound level'
(3) Recall Button
Push the Recall Button to activate the on¬
screen display.
The current. Programme Number will be
displayed.
(4) Contrast Control
Adjust for proper contrast level.
(5) Sharpness Control
Adjust for sharpness of the picture.
(6) Vertical-Hold Control
Adjust this control if the picture rolls either
up or down.
(7) Colour / Brightness Selection Button
Push the Colour/Brightness Button.
The “CLR” or “BRT” indication will appear
on the screen. Push either the Up “-I-” or
the Down ” Button to change the level of
the selected function as shown below.
Colour function Brightness function
a) Push the ‘‘-I-” Button to increase the
level of selected function level.
b) Push the ” Button to decrease the
level of selected function level.
(8) AFC Button
Under normal reception conditions, the AFC
Button is not used.
However, in areas of poor reception or con¬
stant interference, a slight adjustment of the
tuning may improve the picture and sound
quality.
How to cancel the AFC
1. Push the “PRE.” (PRESET) Button until
the on-screen display appears.
2. Push either the Tuning Up “A” or Down
Button for slight adjustment.
3. Push the “AFC” Button. The symbol
appears at the left side of the programme
number on the screen.
AFC OFF symbol appears
4. Push the “PRE.” (PRESET) Button
again.
- 5 -