9
6 Service Mode
6.1. How to enter into Service Mode
6.1.1. Purpose/
After exchange parts, check and adjust the contents of adjustment mode.
While pressing [VOLUME ( - )] button of the main unit, press [INFO] button of the remote control three times within 2 seconds.
Note:
Service Mode can not be entered when 3D signal input.
Input 2D signal to enter Service Mode.
6.1.2. Key command
[1] button...Main items Selection in forward direction
[2] button...Main items Selection in reverse direction
[3] button...Sub items Selection in forward direction
[4] button...Sub items Selection in reverse direction
[VOL] button...Value of sub items change in forward direction ( + ), in reverse direction ( - )
6.1.3. How to exit
Switch off the power with the [POWER] button on the main unit or the [POWER] button on the remote control.
6.1.4. Contents of adjustment mode
• Value is shown as a hexadecimal number.
• Preset value differs depending on models.
• After entering the adjustment mode, take note of the value in each item before starting adjustment.
Main item Sub item Sample Data Remark
ADJUST CONTRAST 000
COLOR 3A
TINT 00
SUB-BRT 800
BACKLGT FFF
B-Y-G 40
R-Y-A 00
V COM 000
WB-ADJ R-GAIN 80
G-GAIN 76
B-GAIN 59
R-CENT 82
G-CENT 80
B-CENT 6D
OPTION Boot ROM Factory Preset.
STBY-SET 00
EMERGENCY ON
CLK MODE 01
CLOCK FFF
EDID-CLK HIGH
SRV-TOOL 00 See next.
To Next Page
Loading...
