First Time Setup
"First time setup" is displayed only when the TV is turned on for the first time after the power cord is
inserted into a wall outlet and when "Auto power on" (p. 36-37) is set to "No".
Turn the TV On with the POWER button
POWER
or
(TV) :Remote)
* This setting will be skipped next time if you select "Home".
<_ Select your language
select
_2)ok
_ Be sure to select "Home"
® Please confirm your selection (Home) before pressing OK button.
• If you select "Store" by mistake in @, confirmation screen will be
displayed.
® Select "No" and return to previous screen @.
® If you select "Yes", Screen enters store demonstration mode.
To display the "Please select your viewing environment" screen again as
shown above and select "Home", do one of the following:
• Press and hold down the front POWER button.
• Unplug the TV and plug it again.
Auto channel setup
Select "ANT/Cable setup"
16
• Press to exit from
a menu screen
EXIT
• Press to return
to the previous
screen
RETURN
@
Select "ANT in"
:; " Zi Cable: Cable TV
) Antenna: Antenna
____ ......... Not used: Skip TV tuning
i (<select _ go to @
Select "Not used" when no wire is connected to the "Antenna/Cable" terminal.
® Typical when Cable/Satellite box is connected to a TV input.
® Prevents accidental tuning to an unavailable signal.
To Next Page
Loading...
