Select"Autoprogram"
@ Select scanning mode (ALLchannels/Analogonly/Digitalonly)
• Press to exit from
a menu screen
EXIT
¢ To change setting
(Language/
ANT/Cable setup/
Network setting/
VIERA CAST setting/
Clock/Input labels)
later, go to Menu
screen
(p. 36)
Start scanning the channels
® Available channels (analog/digital) are automatically set.
All channels: Scans digital and analog channels
Analog only: Scans Analog channels only
Digital only: Scans Digital channels only
_5_Confirm registered channels
"Apply"
® If OK is not pressed after selecting "Apply", the channels will not be saved.
The channel will be saved when no operation is performed for 60 seconds and
the "Manual program" menu will also exit automatically.
® If you perform scanning more than twice, previously saved channels are erased.
Network setting
Network setting (p. 44-45)
VIERA CAST setting
VIERA CAST setting (p. 46-47)
@
"77
m,
3
dD
O0
GD
t-
17
To Next Page
Loading...
