Panasonic TC-P42ST30 - Remove the S-Board; Remove the Contact Metal Bottom B; Remove the Plasma Panel Section from the Cabinet Assy

25
8.15. Remove the S-Board
1. Remove the screws (×2 ) and remove the S-Board
unit.
2. Remove the screws (×2 ).
3. Disconnect the connector (S10) and remove the S-Board
from the Power button bracket.
8.16. Remove the Contact metal bot-
tom B
1. Remove the Stand bracket. (See section 8.11.)
2. Remove the screws (×5 , ×7 , ×1).
3. Remove the Contact metal bottom B.
8.17. Remove the Plasma panel sec-
tion from the Cabinet assy.
1. Place the Cabinet assy on a flat surface of a table (cov-
ered by a soft cloth) and a cushion.
2. Remove the Contact metal bottom B. (See section 8.16.)
3. Remove the screws (×6 ).
4. Remove the Plasma panel section from the Cabinet assy.
8.18. Remove the Contact metals
1. Remove the Cabinet assy. (See section 8.17.)
2. Remove the Tape from the Contact metals.
3. Remove the screws (×8 ).
4. Remove the Contact metal side (L, R).
5. Remove the screws (×6 ).
6. Remove the Contact metal top.
7. Remove the screws (×15 ).
8. Remove the Contact metal bottom A.