23
8 Measurements and Adjustments
8.1. Adjustment Procedure
8.1.1. Driver Set-up
8.1.1.1. Item / Preparation
1. Input a white signal to plasma video input.
2. Set the picture controls as follows.
Picture menu: Vivid
Normal: Set
Aspect: Full
Caution
1. First perform Vsus adjustment.
2. Confirmation of Vscn voltage should be performed after
confirmation of Vad adjustment.
When Vad=-180V, Voltage of Vscn is -35V ±4V.
8.1.1.2. Adjustments
Adjust driver section voltages referring the panel data on the
panel data label.
Check or adjust the following voltages with the multimeter.
*See the Panel label.
Name Test Point Voltage Volume Remarks
Vsus TPVSUS
(SS)
Vsus ± 2V R737 (P) *
Ve TPVE (SS) Ve ± 2.5V Fixed *
Vset TPVSET
(SC)
290V ± 9V Fixed
Vad TPVAD (SC) -180V ± 1V VR16600
(SC)
Vscn TPVSCN
(SC)
Vad + 145V ± 4V Fixed
Vda TPVDA (P) 60V + 1V, - 2V Fixed
To Next Page
Loading...
