24
9.2.25. Remove the Cabinet assy from the
Plasma panel section.
1. Place the Cabinet assy on a flat surface of a table
(covered by a soft cloth) and a cushion.
2. Remove the screws (×14 ).
3. Remove the Cabinet assy from the Plasma panel section.
9.2.26. Remove the Contact metals
1. Remove the Tape from the Contact metals.
2. Remove the screws (×10 ).
3. Remove the Contact metal side (L, R).
4. Remove the screws (×15 ).
5. Remove the Contact metal bottom A.
9.2.27. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
2. Disconnect the flexible cable (C10).
3. Disconnect the connector (C14).
4. Remove the screws (×4 ) and remove the C1-Board.
To Next Page
Loading...
