22
9.2.16. Remove the M8 nut metals
1. Remove the screws (×2 each) and remove the M8 nut
metals.
9.2.17. Remove the K-Board
1. Remove the screws (×2 ) and remove the LED panel
case.
2. Disconnect the connector (K10).
3. Remove the claw (×1 ) and remove the K-Board.
4. Remove the LED panel.
9.2.18. Remove the Cabinet assy from the
Plasma panel section
1. Place the Cabinet assy on a flat surface of a table
(covered by a soft cloth) and a cushion.
2. Remove the screws (×26 ).
3. Remove the Cabinet assy from the Plasma panel section.
To Next Page
Loading...
