Panasonic Technics SL-1800

@ Parts identification
AC power plug
Hinge
Turntable mat
Turntable platter
Motor shaft
(Center spindle)
Stobe dots
Strobe mark
Strobe illuminator/
pilot lamp
Speed selector
Pitch control knobs
Assembly and set-up
Apply two or three drops of oil to the motor shaft
using the furnished oil container. (See Fig. 2)
Although the unit has been lubricated before shipping
from the factory, apply a few drops of oil to the
motor shaft for assurance. After that, application of
two or three drops of oil once every 2000 hours’
operation or so is sufficient. The time interval ts
much longer than that of the former type motors
Phono cables
Output terminals
Ground wire
Balance weight
Stylus pressure ring
Anti-skating control Knob
Cueing lever
Arm rest
Arm clamp
Tubular arm
Locking nut
Switch lever
Head shell
Turntable base
(1)
For
removal
of
the
cover,
take
off
4
vis-screws
from
the
panel
cover.
(2) Draw out three connectors.
(3)
For
separation
of
the
body
from
the
main
base,
turn
the
cueing
lever
upward,
move
the
tone-arm
in
inboard
direction,
then
lift
up
the
body.
Note:
(200
-
500
hours),
so
do
not
apply
too
much
oil,
nor
The
turntable
horizontaliy
to
the
panel
face
is
more
frequently
than
necessary.
Never
use
any
other
already
adjusted
before
shipment.
type of oil. lf deviated, correct it by means of the adjust
screws using a 5mm box spanner.
Screw, audio
insulation
adjustment
Panel,
Aurntable case
i
|
Lever, cueing
Connector ”
1.
Remove
the
cartrige.
oe
base
Main
base
2.
Fix
the
tone
arm
to
the
arm
rest.
ne
@
at
|
3. Remove the turntable.
4.
Turn
the
player
set
upside
down
with
good
care
not to damage the acry| cover.
5. Take off 4 vis-screws from the back panel.
6.
Place
the
player
set
face
upward
holding
it
with
both
hands
so
that
the
body
is
not
separated
from
the
main
body.
SL-1800/SL-1800A