Auto
program
Set
automatically
Automatically searches and adds available channels to the memory.
Select “Auto program”
Start scanning the channels
(Available channels are automatically set.)
After the scanning is completed, select “Apply”.
(see below )
All previously saved channels are erased.
Manual
program
Set
manually
Use this procedure when changing the channel setup or
changing the channel display.
Also, use this to add or skip channels from the channel list
manually.
Edit
Caption
Caption
Select the station identifier.
Add
Press OK to select “Yes (add)” or “No (skip)”
Move the cursor to a channel number
Select “Apply”
Select “Edit”
Select the item to edit
•
Caption:
Changes the station identifier
•
Add:
Adds or skips channels
To cancel the Edit
Signal
meter
Check signal
strength
Check the signal strength if interference is found or freezing occurs on a digital image.
If the signal is weak, check the antenna.
If no problem is found, consult your local dealer.
Note
Available only for digital antenna channels.
Editing and Setting Channels
The current channel settings can be changed according to your needs and reception
conditions.
Press to exit from
a menu screen
Press to return
to the previous
screen
Display the menu
Select “ANTENNA/Cable setup” in “Setup”
next
select
Select the function
next
select
Set
To Next Page
Loading...
