19
Tuning menu – Manual tuning
Press the MENU button.
Move to choose Setup menu.
Access Setup menu.
Move to choose Tuning menu.
Access Tuning menu.
Move to choose Manual tuning.
Access Manual tuning.
Select the programme position to be tuned.
Press repeatedly until required station is found.
When the desired station is found, press the OK button to store.
The programme position will flash.
Press the EXIT button at any time to go back to watching TV.
It is possible to retune individual programme positions:
It is also possible to use the control panel buttons on the front of your TV to tune individual programme positions:
Press the F button until Tuning mode is reached.
Press the
-
/ or +/ button to access Tuning mode.
Press the TV/AV button to move between Change
programme, Search and Change TV system.
Press the
-
/ or +/ button to change programme position
or start search.
When the desired station is found, press the STR button
to store.
The programme position will flash.
Repeat above procedure to tune additional programme
positions.
Press the F button at any time to go back to watching TV.
Note:
When using a VCR without video and audio input / output terminals, it is convenient to connect the antenna cable
as indicated in the instruction book of VCR and to set the designated channel to programme No.“0”. In that case,
perform Manual tuning after setting the Colour system in advance. Further, in multi-system VCR, it is more convenient
to set the designated channel to several programme numbers.
SC1
CH12
1
Manual tuning
02 78:01 41
-
, + : Search
TV / AV : Move cursor
STR : To store
F : To exit
STR F
-
/ + / TV / AV
S VIDEO
AV3
VIDEO
LR PC
STR F TV/AV
/ /
SD CARD
PUSH-EJECT
PC CARD EJECT
STR F TV/AV/ /
Manual tuning
Return Exit
Store
Search
down/up
Programme
down/up
02 78:01 41
CH12
1
MENU
EXIT
OK
TV
123
456
789
C
0
OK
N
F
To Next Page
Loading...
