2) Carefully remove the top of the crate,
remember you will have to reuse the crate
to return ship the defective panel. Slide the
panel out the opened end.
3) The replacement panel is packed in an
escutcheon frame and a cardboard
panel. Protective cushioning surrounds the
panel. These items must be saved and
used to return the defective panel.
Figure 2
Figure 3
4) Remove the four screws that secure the protective cardboard on the new panel.
Place the protective cardboard aside.
Figure 4a
Figure 4b
Unwrap the protective packaging from the new
panel.
Important Note:
The new panel comes with the “C” boards
preinstalled. However, the jumper ribbon
cables that connect the “C” boards may not be
included. Check for board jumpers. If missing,
remove them from the old panel and transfer
them to the new panel.
Figure 5
5) Reverse the order of the steps listed above to repack the defective panel for
return shipment to Panasonic.
Page 2 of 2
To Next Page
Loading...
