Maintenance
First, unplug the Power cord plug from the wall outlet.
The front of the display panel has been specially treated. Wipe the panel surface gently using only a cleaning cloth or
a soft, lint-free cloth.
@If the surface is particularly dirty, soak a soft, lint-free cloth in diluted neutral detergent (1 part detergent diluted by
100 times the amount of water) and then wring the cloth to remove excess liquid. Use this cloth to wipe the surface
of the display panel, then wipe it evenly with a dry cloth of the same type until the surface is dry.
@Do not scratch or hit the surface of the panel with fingernails or other hard objects. Furthermore, avoid contact
with volatile substances such as insect sprays, solvents, and thinner; otherwise, the quality of the surface may be
adversely affected.
If the cabinet becomes dirty, wipe it with a soft, dry cloth.
@If the cabinet is particularly dirty, soak the cloth in a weak detergent solution and then wring the cloth dry.
Use this cloth to wipe the cabinet and then wipe it dry with a dry cloth.
@Do not allow any detergent to come into direct contact with the surface of the Plasma TV.
If water droplets get inside the unit, operating problems may result.
@Avoid contact with volatile substances such as insect sprays, solvents, and thinner; otherwise, the quality of the
cabinet surface may be adversely affected or the coating may peel off. Furthermore, do not leave it for long periods
in contact with articles made from rubber or PVC.
@Cleaning
Wipe the surfaces with a soft, dry cloth. If the unit is particularly dirty, clean it using a cloth soaked with water to
which a small amount of neutral detergent has been added and then wipe with a dry cloth.
Do not use products such as solvents, thinner, or household wax for cleaning, as they can damage the surface
coating. (If using a chemically-treated cloth, follow the instructions supplied with the cloth.)
@Do not attach sticky tape or labels, as they can make the surface of the pedestal dirty. Do not allow long-term
contact with rubber, vinyl products, or the like. (Doing so will cause deterioration.)
Specifications
AC 120V, 60Hz
Maximum 387 W 499 W
Standby condition 0.2 W 0.2 W
i@ Drive method ACtype
16:9
:_ Visible screen size 106 cm 127 cm
(Wx H x Diagonal) 36.3 x 20.3 x 41.6"
.... 43.5 "x 24.4" x 49.9 "
(Nol,,nf _-, _,,r'ix"lS_ 922 mm x 518 mm x 1,057 mm) (1,106 mm x 622 mm x 1,269 mm)
786,432 (1,024 (W) x 768 (H)) 1,049,088 (1,366 (W) x 768 (H))
3,072x 768 dots] [4,098 x 768 dots]
20W[10W+ 10W](10%THD)
VHF/UHF: 2-69, CATV: 1-135
Temperature: 32 °F - 104 °F (0 °C - 40 °C)
Humidity: 20 % - 80 % RH (non-condensing)
lil;! f VIDEO: RCA PIN Type x 1 1.0 V [p-p] (75 _)INPUT 1-3 S-VIDEO: Mini DIN 4-pin Y: 1.0V [p-p] (75 _) C: 0.286 V [p-p] (75 _)
_' AUDIOL-R: RCAPINTypex2 0.5V[rms]
COMPONENT VIDEO Y: 1.0V [p-p] (including synchronization)
_+035v[p-p
AUDIO L-R: RCA PIN Type x 2 0.5 V [rms]
HDMI 1-2 TYPE A Connector x 2
@ This TV supports "HDAVl Control 2" function.
AUDIO IN AUDIO L-R: RCA PIN Type x 2 0.5 V [rms]
: _': card slot SD CARD slot x 1
i !iii_ iiiiii
VIDEO: RCA PIN Type x 1 1.0 V [p-p] (75 £2)
AV PROG. OUT AUDIO L-R: RCA PIN Type x 2 0.5 V [rms]
DIGITAL AUDIO OUT PCM / Dolby Digital, Fiber Optic
3D YiC FILTER
CLOSED CAPTION V-Chip
Photo Viewer HDAVI Control 2
44.7 " x 27.1 " x 13.0 " 52.1 " x 31.6 " x14.6 "
(1,134 mmx 688 mm x 330 mm) (1,323 mm x 802 mm x 369 mm)
44.7 " x 25.3 " x 3.92 " 52.1 " x 29.7 " x 3.92 "
(1,134 mm x 641 mm x 99.5 ram) (1,323 mm x 754 mm x 99.5 ram)
Including pedestal 77.2 lb. (35 kg)
TV Set only 61.8 lb. (28 kg)
103.7 lb. (47 k_:)
88.2 lb. (40 kg)
[TH-42PX77U]
I_ 443 (1,134 mm) ,1392 (99.5 mm)
1,263 " (676 mm) l 13.0 ,,(_'_30 mm)
3.92 " (99.5 mm)
14.6 " (369 mm)
@Design and Specifications are subject to change without notice. Mass and Dimensions shown are approximate.
-i
-1 0
O -1
Go
5O 51
To Next Page
Loading...
