CD mode
Select the CD mode by Up/Down button on the remote control at the front page of CAT mode and then press
the Mute button on the remote control more than 3 seconds.
Memory data change
To exit the CD mode, press the R button on the remote control.
SD mode
Select the SD mode by Up/Down button on the remote control at the front page of CAT mode and then press
the Action button on the remote control.
To exit the SD mode, press the R button on the remote control.
Input command
check
MTBF Parameter WT PT
TE
Condition
Sensor
SD
History of remote control command.
(Faktory use).
Cumulative Time for power on condition. (unit :hour)
Temperature of A-board
OSD
4F 4E 4A 4B 4A 4E 4F
4E 4F 4E 4F 4E 4F 20
21 22 21 34 4B 49
4
0
+25
Counter of power on. (unit :time)
MONITOR-MCU 1.0100S30 OK
MONITOR-EEPROM 01.00 20 2152
MONITOR-EEPROM Change Addr 00 00
Data 03 03
MONITOR SUB MCU 01.01
BOARD EEPROM PC -- -- -- --
BOARD --/--/-- -- -- --
PTCT 00. 00. 00. 00. 00.
CD
Factory use
New data
Original data
SOS history
0
0
ddress
Change by Up/Down buttons on the remote control.
Change by Left/Right buttons on the remote control.
0
0
Data
Change by VOL Up/Down buttons on the remote control.
The data is memorized when switch off the main power.
118
Contrast Automatic Tracking System sensor
0
To Next Page
Loading...
