3D Eyewear - Replacing battery
For active shutter 3D
When the battery is running low, the indicator lamp flashes 5 times on turning
the 3D Eyewear on. In this case, early battery replacement is recommended.
●
Dispose of the old battery as non-burnable rubbish, or in line with the
waste disposal regulations in your local area.
1. Remove the battery cover using pen tip or screwdriver (minus -), etc.
2. Replace the battery (coin-shaped lithium battery CR2025).
●
If you have difficulty, remove it with the tip of the driver.
●
Make sure the polarity is correct (+ or -).
3. Attach the battery cover.
- 96 -
To Next Page
Loading...
