34
Editing and Setting Channels
The current channel settings can be changed according to your needs and reception
conditions.
Select "Setup"
Select "Program channel"
• Press to exit from
menu screen
EXiT
@
Select the function
Set
II To reset th: settings of setup menu -I
_ Select Reset in Setup menu (_'_)and press OK 1
@ Input your 4:,digit password with number buttons 1
_ Select 'YES on the confirmation screen and press OK
Auto
il
Manual
Signal
meter
Automatically searches and adds active channels to memory.
_i_Select "ANT in" ÷Select Cable orAntenna _3_Select scanning mode (p. 19)
(p. 19)
_2_Select "Auto"
Settings are made automatically
@After completing the setting, select "Apply". (see below @).
@All previously saved channels are erased.
Use this procedure when changing setting of receiving
channels or changing the channel display.
Also, use to add or skip channels from channel list
manually.
_1_Select "Edit"
_Select the item to be edited
Favorite
Caption Add
_'_J _J
R G
Proceed to
next page
Go back to previous page
@Caption:
Changes the station identifier
@Favorite:
Registers channel to Favorite
List
@Add:
Adds or skips channels
_3_Edit
I Capti°nI [ Caption detail ]
Select the station identifier Rename(maximum7charactersavailable)
@Favorite
I Set favorite I Select the number
@Add
Press OK to select "Yes (add)" or "No (skip)" RETURN
@Move cursor to channel number @
@Select "Apply"
)Press OK to tune
to the channel.
To cancel the Edit
Check the signal strength if interference is found or freezing occurs on a digital image.
-_w_change channei
5ok
intensity
@If the signal is weak, check the antenna.
If no problem is found, consult your
local dealer.
f Note
\
@Not available if "Cable" is selected in "ANT in"
(see above).
@Effective only for digital antenna channels.
@If "Lock" (p. 32) is activated and "Auto", "Manual" or "Signal meter" is selected, "Enter password." will be displayed.
nq
Q.
G:3
tm
03
O
::3"
GO
35
To Next Page
Loading...
