26
English
Basic Controls
AC socket outlet
Remote control sensor / Power Indicator
Main power switch (
)
(Unit) (Back of the unit)
Power button (
) (Unit) (Back of the unit)
AC cord
(supplied)
Operate pointing the remote control directly at the unit’s
Remote Control Sensor.
Note
●
Do not put an obstacle between the remote control
sensor of the main unit and the remote control.
●
Operate the remote control in front of the remote
control sensor or from the area where the sensor can
be seen.
●
When directly aiming the remote control at the remote
control sensor of the main unit, the distance from
the front of remote control sensor should be approx.
7 m or less. Depending on the angle, the operation
distance may be shorter.
●
Do not subject the remote control sensor of the main
unit to the direct sunlight or strong fluorescent light.
1
Connect the AC cord plug to the TV.
(see page 16)
2
Connect the plug to the socket outlet.
Note
●
When disconnecting the AC cord, be absolutely
sure to disconnect the AC cord plug at the
socket outlet first.
●
The settings may not be saved if the power plug
is disconnected immediately after changing
settings with on-screen menu. Disconnect the
power plug after a enough period of time. Or,
disconnect the power plug after turning the
power off with the remote control, RS-232C
control or LAN control.
3
Turn ON ( ) the <Main power switch
( )> on the unit.
4
Press the <Power button ( )> on
the unit to turn the power of the unit
ON.
●
Power Indicator: Green (Picture is displayed.)
●
When the <Main power switch> is ON (
), the
power indicator lights up and remote control
operation is possible.
●
When the power indicator is lit, it is not necessary
to press the <Power button (
) (Unit)> on the
unit. Operate the remote control so that the power
indicator turns green (picture is displayed).
To Next Page
Loading...
