EasyManua.ls Logo

Panasonic TH-86CQ2U - Network Settings

Panasonic TH-86CQ2U
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
English
[Input]
Specifies the input when the power is turned by
programs.
Note
●
When [On time] or [Off time] is not set, the display
shows [--:--] (not set).
●
When [On time] and [Off time] are set
simultaneously, or when only [On time] is set, the
power is turned on at the set time.
●
[On time] and [Off time] can be set from 00:00 to
23:59 on the same date. [Off time] cannot be set
before the time set for [On time].
Network settings
Selects the method with which to control the TV from the
computer.
[Network settings] submenu will be displayed.
SERIAL IN/LAN select LAN
LAN setup
Network settings
[SERIAL IN/LAN select]
RS-232C or LAN function is enable. To control the TV
via RS-232C, set [SERIAL IN/LAN select] to [SERIAL
IN].
Note
●
You cannot use RS-232C and LAN control
simultaneously.
[LAN setup]
Controls via LAN using the LAN terminal.
Network information
DHCP
IP address
Subnet mask
Gateway
PJLInk Password(Web)
Set
LAN setup
No Use
. . .
. . .
. . .
PJLink Off
[Network information]
DHCP
IP address
Subnet mask
Gateway
MAC address
No Use
192 . 168 . 000 . 007
255 . 255 . 255 . 000
192 . 168 . 000 . 001
00 : 00 : 00 : 00 : 00 : 00
SERIAL IN/LAN select LAN
[DHCP], [IP address], [Subnet mask], [Gateway]
Press < > to set [Use] / [No Use] of [DHCP].
When [No Use] is selected, IP address and other
settings can be set manually.
[DHCP]:
[Use]: Use Dynamic IP address.
[No Use]: Use Static IP address, Subnet
mask, and Gateway.
[IP address]:
Enter IP address when [DHCP] is [No Use].
[Subnet mask]:
Enter Subnet mask when [DHCP] is [No Use].
[Gateway]:
Enter Gateway address when [DHCP] is [No
Use].
Note
●
When [DHCP] is set to [Use], others will be
displayed in grey.
Entering numbers
Network information
DHCP
IP address
Subnet mask
Gateway
PJLInk Password(Web)
Set
LAN setup
No Use
. . .
. . .
. . .
PJLink Off
1. Select the address and press <ENTER>.
2. Select digits with the cursor buttons <
/ >.
3. Change numbers with the cursor buttons
<
/ > and the numeric buttons <0 - 9>.
4. Press <ENTER>.

Table of Contents

Related product manuals