Panasonic TH-P50S10D

20
7.5. Remove the A-Board
1. Remove the Tuner unit. (See section 7.4.)
2. Remove two EDGE SADDLES at top of case.
Twist the EDGE SADDLE to press up at the back and
pull down the front side.
3. Remove the screws (×4 ) and remove the A-Board.
Caution :
Press up the case not to touch the leg of clamper to the A-
board.
Pay attention two metal projection from back side when
removal and assemble.
7.6. Remove the Speakers
1. Unlock the cable clampers to free the cable.
2. Disconnect the relay connector.
3. Remove the screws (×2 ) and remove the Speaker R.
4. Disconnect the connector (A12). (See section 7.4.)
5. Remove the screws (×2 ) and remove the Speaker L.
7.7. Remove the Control button unit
1. Disconnect the connector (C24).
2. Remove the screws (×2 ).
3. Remove the Control button unit.