16
• Keep all parts that are not used during installation, as they may be needed later if the unit is moved or the faucet
is changed.
• 沒有使用到的零件，請妥善保存，以備搬家或購買新水龍頭時之需求。
Faucet without an aerator
• Water faucet which can attach the Alkaline Ionizer with
accessory.
無充氣器的水龍頭時
• 需用一附件才能將電解水生成器連接到水龍頭上。
Remove the mounting nut and
adaptor.
卸下螺帽和轉接器。
1
Insert the installation adaptor,
and tighten it with the mounting
nut.
插入安裝轉接器並用螺帽將其緊固。
2
➀
more than 10 mm
➁
greater than 13 mm, less than 24 mm
➀
10 毫米以上
➁
在 13 ～ 24 毫米之間
Return to the original
position after removing.
卸下後，將其放回原位。
Mounting nut
螺帽
Adaptor
(Not used)
轉接器
（不使用）
Do not remove the gasket
inside the bypass selector.
不要卸下分水開關內的墊片。
Remove the screws.
(4 pcs.)
卸下螺絲（4 個）。
Mounting nut
螺帽
Installation adaptor
(Accessory)
安裝轉接器（附件）
Attaching the Bypass Selector (continued)/安裝分水開關（接續）
Bulge
膨脹部
➀
➁
➀
➁
ZGS0TKAS400EXZ.indb 16ZGS0TKAS400EXZ.indb 16 5/11/2010 3:28:44 PM5/11/2010 3:28:44 PM
To Next Page
Loading...
