Panasonic TX-29FG50A - Auto Tuning Procedures; Remote Control Auto Tuning; Front Panel Auto Tuning

-4r
.1~9FG50A,M-2833JJ-fin P..,21 T",,"'y,JM""Y",2005 5 13 PM
-t
r
C Tuning menu)
.Auto tuning (Via Remote control)
Before Auto tuning, set the .Sys selecf mode.
1 Press ()'
2 Move to choose Setup menu option by using Id or~.
3 Access Setup menu mode by using E] or (I3.
4 Move to choose Tuning menu option by using Id or ~.
5 Access Tuning menu by using ED or 1I:3.
6 Move to choose Auto tuning by !d or ~.
1 Access Auto tuning by using E1J or [::3 .
Once this operation is completed, the TV will display the programme now
stored on programme position 1.
8 Press <3 at any time to go back to watching TV.
OR
Press the () button three times.
~
-E
.Auto tuning (Via front panel)
It is also possible to use the control panel buttons on the front of the TV to tune individual programme positions.
I ..I 1 Press 0 (front panel) setting to Main Menu mode.
IEIII
2 Press 0 or 0 to select Setup menu in Main Menu.
I v A
3 Press 0 or 0 to access Setup menu.
'=
4 Press 0 or 0 to select Tuning menu.
v A
5 Press 0 or 0 to access Tuning menu mode.
6 Press 0 or 0 to select Auto tuning.
v A
1 Press 0 or 0 to start search.
8 Press 0 button 3 times to exit the Tuning menu.
MENU
OR
Press 0 at any time to go back to watching TV.
TV/AV
1. If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to
the "Colour System Selection" operation on page 19.
2. Alter the Auto tuning is finished, press the Programme Number "Up" button to confirm the tuning condition for
each Programme Number. If some Programme Numbers are unused, it is possible to skip such Programme
Numbers. Please refer to the Programme Skip function on page 19.
21
~
-+
--t-