Setup
When the TV is turned on for the first time, it will
automatically search for available TV channels and give
options to set up the TV.
≥ These steps are not necessary if the setup has been
completed by your local dealer.
≥ Please complete connections (p. 13 - 16) and settings
(if necessary) of the connected equipment before
starting Auto Setup. For information about the settings
for the connected equipment, read the manual of the
equipment.
1 Plug the TV into a live mains socket
and turn the power on
2 Select the following items
Set up each item by following the on-screen instructions.
Example:
∫
∫
∫
∫∫ How to use the remote control
Select the language
Select your country
Select [Home]
Select [Home] for use in a home viewing environment.
≥ [Shop] is for shop display.
≥ To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Shipping Condition].
Set up the network connection
≥ Depending on the country you select, select your
Region or store the Child Lock-PIN number (“0000”
cannot be stored).
Tick the TV signal mode to tune, and then select
[Start Auto Setup]
≥ Auto Setup screen varies depending on the country
and the signal mode you select.
≥ [DVB-S Antenna Setup]
Ensure the satellite connections are completed (p. 14)
and select the tuner mode ([Dual Tuner] / [Single
Tuner]).
≥ [DVB-C Network Settings]
Normally set [Frequency] and [Network ID] to [Auto].
If [Auto] is not displayed or if necessary, enter
[Frequency] and [Network ID] specified by your cable
provider with numeric buttons.
Space Tune Adjustment
If tuning has failed check the Satellite cable, RF cable,
and the network connection, and then follow the on-
screen instructions.
≥ The TV goes into Standby mode when no operation is
performed for 4 hours if [Auto Standby] in the Timer
menu is set to [On] (factory setting).
≥ The TV goes into Standby mode when no signal is
received and no operation is performed for 10 minutes
if [No signal Power off] in the Timer menu is set to [On]
(factory setting).
≥ To retune all channels
[Auto Setup] in [Tuning Menu] ([Setup] menu)
≥ To add the available TV signal mode later
[Set up TV Signals] ([Setup] menu)
≥ To initialise all settings
[Shipping Condition] in [System Menu] ([Setup]
menu)
≥ Takes a few seconds to be displayed.
Move the cursor
Access the item / store the setting
Return to the previous item (if available)
To Next Page
Loading...
