Panasonic TY-ER3D4MA - Part Names and Functions

Viewing 3D images
31
Part names and functions
Ɣ
3D Eyewear can be worn over vision correction glasses.
Power switch
Slide the tab to the “ON” / “OFF” position to switch the power on/off.
Each time slide the tab to the “MODE” position to change the mode
between 3D and 2D (view a 3D image in 2D).
Registration
(p. 32)
Indicator lamp
Lights or flashes during use to show the status.
Battery cover
Ɣ
When using for the first time, remove the insulating sheet. Pull the
insulating sheet.
Ɣ
To replace the battery “Replacing the battery” (p. 33)
Insulating sheet
Pull
Ŷ Indicator lamp status
Indicator lamp Status
Lights red for 2 seconds when turned on Sufficient battery level
Flashes 5 times when turned on Low battery level
Flashes red and green alternately Under pairing
Flashes green once every 2 seconds Under reconnecting to the TV
Lights green for 3 seconds Pairing or reconnecting is successfully completed.
Flashes red 3 times
Automatically power off (Pairing or connecting fails or
connection is lost)
Flashes red once every 2 seconds when in use 3D mode is selected
Flashes red twice every 4 seconds when in use 2D mode is selected
Storing and cleaning the 3D Eyewear
Ɣ
Use the supplied 3D Eyewear case to store the 3D Eyewear.
Ɣ
Avoid storing the 3D Eyewear in hot or highly humid locations.
Ɣ
Use a clean, soft and dry cloth to wipe the 3D Eyewear. Otherwise, dirt or dust may scratch the eyewear.
Ɣ
Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
Ɣ
Do not submerge the 3D Eyewear in liquid such as water when cleaning.
Ɣ
As the liquid crystal shutters (lens) are fragile and easily broken, be very careful when cleaning them.