EasyManua.ls Logo

Panasonic TY-ER3D4MA - Replacing the Battery

Panasonic TY-ER3D4MA
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Viewing 3D images
33
Replacing the battery
When the battery is running low, the indicator lamp flashes 5 times on turning the 3D Eyewear on.
In this case, early battery replacement is recommended.
Ɣ
Dispose of the old batteries as non-burnable rubbish, or in line with the waste disposal regulations in your local area.
1 Loosen the screw and remove the cover using with a precision Phillips (No.0, plus + ) screwdriver.
Ɣ
The screw is not removed from the cover.
2 Replace the battery
Ɣ
If difficulty, remove it with the tip of the driver.
Ɣ
Use the specified type of battery (coin-shaped lithium
battery CR2032).
Ɣ
Note the correct polarity (+ or -).
3 Replace and fasten the cover.
Ɣ
Push the cover firmly until it clicks
Ɣ
Tighten the screw

Related product manuals