2WAY SYSTEM
Remote Controller Functions
5 - 8
2. Detailed Settings Function
5
<Procedure of CZ-RTC5A>
1
Keep pressing the , and
buttons
simultaneously for 4 or more seconds.
The “Maintenance func” screen appears on the
LCD display.
2
Press the or button to see each
menu.
If you wish to see the next screen instantly, press
the or button.
Select “8. Detailed settings” on the LCD display
and press the button.
The “Detailed settings” screen appears on the
LCD display.
Select the “Unit no.” by pressing the or
button for changes.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
Sel. Page [ ] Confirm
20:30 (THU)
Maintenance func
5. Sensor info.
6. Servicing check
8. Detailed settings
Sel. Page [ ] Confirm
20:30 (THU)
7. Simple settings
Detailed settings
Unit no. Code no. Set data
10
3-1 0001
Sel. Next
20:30 (THU)
3
Select the “Code no.” by pressing the or
button.
Change the “Code no.” by pressing the or
button (or keeping it pressed).
4
Select the “Set data” by pressing the or
button.
Select one of the “Set data” by pressing the
or button.
Then press the button.
5
Select the “Unit no.” by pressing the or
button and press the button.
The “Exit detailed settings and restart?” (Detailed
setting-end) screen appears on the LCD display.
Select “YES” and press the button.
Detailed settings
Unit no. Code no. Set data
3-1 0001
Sel. Next
20:30 (THU)
10
Detailed settings
Unit no. Code no. Set data
3-1
Sel.
20:30 (THU)
10 0001
Detailed settings
Unit no. Code no. Set data
ALL
Sel. Next
20:30 (THU)
01 0002
Exit detailed settings
and restart?
NOYES
SM830231-00Single欧州.indb6 2014/04/0413:48:32
START
[ ]
20:30 (THU)
[ ] Confirm
<Procedure of CZ-RTC4>
1
Press and hold the and , buttons
simultaneously for 4 seconds or longer.
2
“ ”, unit No. “ ”, item code “ ”, and
settings data “” are displayed blinking on the
remote controller LCD display. At this time, the indoor
unit fan begins operating.
3
If group control is in effect, press the
select the address (unit No.) of the indoor unit to set.
At this time, the fan at the indoor unit begins operating.
button and
*If unit No. “” is displayed, the same setting
will be made for all indoor units.
4
Press the temperature setting /
select the item code to change.
buttons to
5
Press the timer time / buttons to select the
desired setting data.
*For item codes and setting data, see the following
page.
6
Press the button. (The display stops blinking
and remains lit, and setting is completed.)
7
Press the button to return to normal remote
controller display.
A
°
°
7 6
3
2
5
4
1
•
This allows the system address, indoor unit
address, and other settings to be made for the
individual or group-control indoor unit to which
the remote controller used for detailed settings is
connected.
When detailed settings mode is engaged,
operation stops at the individual or group-control
indoor unit where the remote controller used for
detailed settings is connected. Simple settings
items can also be set at this time.
SM830253-00_欧州2way7_SM-TRSM.indb 8 16/08/02 14:00:28
To Next Page
Loading...
Need help?
General
