To Next PageTo Next PageWhy is the wind direction changing on my Panasonic U-6LE1E5 Air Conditioner and I can't adjust it?
Your Panasonic Air Conditioner may automatically adjust to a horizontal wind flow when the air discharge temperature is low, or during defrost operation. Also, the flap position is occasionally set up individually.
Why does the flap on my Panasonic U-6LE1E5 move several times and then stop when I change the wind direction?
When the wind direction changes on your Panasonic Air Conditioner, the flap operates after searching for a standard position.
Why does the fan on my Panasonic Air Conditioner run faster than the set speed at the beginning?
At the initial high-speed operation, the fan may sometimes rotate faster (for 3 to 30 minutes) than the setting speed. This happens for operation check in order to confirm whether the fan motor rotation is within use range.
What to do if I see fog coming from my Panasonic Air Conditioner?
During defrost operation, fog may be observed. Additionally, if the unit inside (heat exchanger) is dirty, cleaning is necessary. It's recommended to consult with your dealer, as technical engineering is required.
Why does the fan on my Panasonic U-6LE1E5 keep running after I turn it off with the remote?
The fan may continue to rotate for a short period even after you stop the Panasonic Air Conditioner with the remote. This is normal and helps ensure smooth operation.
Why does my Panasonic U-6LE1E5 Air Conditioner sound like water is running?
The sound of streaming water you hear is likely the sound of refrigerant liquid flowing inside the unit during or after operation or the sound of drainage water through the drain pipe.
Why does my Panasonic U-6LE1E5 not start immediately?
Operation is not activated for the first approx. 3 minutes because compressor protection circuit is activated.
Why is my Panasonic Air Conditioner cooling or heating poorly?
If your Panasonic Air Conditioner's cooling or heating performance is poor, check if the air inlet or outlet of the indoor and outdoor units are blocked by dust and remove any dust. Also, ensure the air speed control is set to 'High' or 'Strong'. Verify that the temperature settings are correct by lowering the temperature setting or setting it to 'High' or 'Strong'. Finally, consider that direct sunlight exposure in cooling mode can affect performance.
General| Refrigerant | R32 |
|---|---|
| Sound Pressure Level Cooling (dB(A)) | 20 dB(A) |
| Sound Pressure Level Heating (dB(A)) | 20 dB(A) |
| Cooling Capacity | 1.8 kW |
| Power Supply | 230 V |
