Scanning
22
Remove paper jams by the following procedure
when copy paper does not come out of the output
port or when
“”
flashes on the Display
Window.
1 Push down the printer open lever to
open the printer door.
2 Remove the thermal transfer film.
3 Remove the jammed paper.
4 Install the thermal transfer film, and
then close the printer door.
• Refer to steps 3 and 4 in the section of
“Installing the Thermal Transfer Film” on
page 18.
•
“”
flashing on the Display Window
will go out and “ ” will flash.
Notice
• If
“”
flashes after closing the
printer door, make sure that the thermal
transfer film has been installed properly and
tightened.
• The printer door should be closed to make
copies properly. Confirm both latches are
locked.
• If the flashing
“”
does not go out
after the foregoing procedure has been
performed; this may indicate that the paper
feeder is not functioning properly.
Refer to page 19 to reset the copy paper.
If you press the Copy Key a second time
while “ ” is flashing on the Display Window,
printing will start again.
Paper Jams
UB-5335&5835&5365&5865-PNQX5932ZA-mst.book 22 ページ ２０１２年１１月１２日 月曜日 午前９時４２分
To Next Page
Loading...
