–1–
ACCTB69E 201602-T
BLOCK DIAGRAM
The differential input signal is converted to an optical signal by the Laser Diode Driver (LDD) and Laser Diode (LD) in the
plug.
The optical signal is transmitted through the optical fiber and reproduced as differential output signal by the Photo Diode
(PD) and Trans Impedance Amplifier (TIA).
Vertical insertion type
V Series
Active Optical Connector
FEATURES
1. Plug connector is equipped with electrical/optical conversion function
(bi-direction, Max. 6 Gbps transmission).
2. High speed and wide data rate transmission possible: 20 Mbps to 6 Gbps
3. Integration is possible to a small apparatus with compact, bi-directional
transmission device.
4. Noise reduction and electrical isolation easily achieved.
APPLICATIONS
Recommended for the following high speed device transmission or electrical
isolation applications
Electrical signal
(Differential signal)
[Transmitter]
[Receiver]
Optical signal
Receptacle
Plug
(E/O conversion)
Optical fiber
Electrical signal
(Differential signal)
<E/O Converter>
IC
Laser diode
<O/E Converter>
O/E: Optical/Electrical
conversion
E/O: Electrical/Optical
conversion
IC
Photo diode
• Measuring equipment
• Printer
• Industrial robots, etc.
• Image processing instrument
• Medical equipment
LDD: Laser Diode Driver, LD: Laser Diode, TIA: Trans Impedance Amplifier, PD: Photo Diode
TIA
LD
LDD
LD
TIA
PD
LDD
LD
Differential output
Differential input
Differential input
Differential output
Optical fiber
Downloaded from Arrow.com.
To Next Page
Need help?
General
