Disc and card management
Protecting a disc
85
LSQT1052
Protecting a disc
(RAM) (-RW‹VR›)
This is for preventing recorded contents from being deleted or edited by mistake.
Further recording and editing is not possible on protected discs until the protection is released.
¬Rotate the mode dial to select .
1 Press the MENU button, then select [ SETUP] #
[ DISC PROTECT] and press the joystick.
2 When the confirmation message appears, select [YES], then press the
joystick.
To release disc protection
1) Press the MENU button, then select [ SETUP] # [ DISC PROTECT] and press the
joystick.
2) When the confirmation message appears, select [YES], then press the joystick.
≥ If the disc has been protected on another device, it
may not be possible to release the protection on this
unit. In this case, release the protection on the
device that you used to protect it.
LSQT1052(ENG).book 85 ページ ２００５年１２月２１日 水曜日 午後６時５０分
To Next Page
Loading...
