Automatically searches and adds available channels to the memory.
Select "ANT in" _ Select a scanning mode (p. 13)
®Select "Cable" or "Antenna"
or select "Not used" (p. 13).
_2_Select "Auto program"
Settings are made automatically
@ After the scanning is completed, select "Apply".
(see below (_).
@ All previously saved channels are erased.
Use this procedure when changing the channel setup or _3_Edit
changing the channel display. @ Caption
Also, use this to add or skip channels from the channel list
manually.
You can select a channel tuning mode (Digital only/Analog
only) in "Channel surf mode"(p. 29)
Select "Edit"
_ Select the item to edit
Favorite
Caption Add
¼
R G
_Proceed to
next page
Go backtothe previous
page
® Caption:
Changes the station identifier
® Favorite:
Registers channels to the
Favorite List
® Add:
Adds or skips channels
UBD
DDD
or
_'j lr_ m
m
Select or edit the station identifier.
(maximum 7 characters available)
@ Favorite
select
i
_"_2_set
Set favorite ] Select the number
@ Add RETURN
Press OK to select "Yes (add)" or "No (skip)" @
@ Move the cursor to a channel number
@ Select "Apply"
To cancel the Edit
Check the signal strength if interference is found or freezing occurs on a digital image.
L'I B _ @ If the signal is weak, check the antenna.
H U D If no problem is found, consult your local dealer.
U D m or (_change
channel
m @OK
intensity @ Not available if "Cable" is selected in "ANT in" (see above).
@ Available only for digital antenna channels.
@
FR
tt_
03
tt_
©
::3-
@ If "Lock" (p. 36) is activated and "ANT/Cable setup" is selected, "Enter password." will be displayed. 39
To Next Page
Loading...
