30
etwork Camera
You can operate the Network camera from the TV remote and also check the images from the Network
camera on your TV.
_, VIERA Link control only with the TV's remote control (p. 43)
Preparations
® Internet connections (p. 29)
® Example of Network connection (p. 29)
_ Network settings (p. 44-47)
® Before connecting the Network camera to the TV, please complete "IP setting" and run
"Connection test"(p. 44-47)
With all connected equipment turned on
Display "VIERA Link" menu
w_f,_ u_ If there is no registered camera displayed, please set it in
Network Camera settings. (p. 31 )
® There is also an option to start with sensor detection.
Select "Network camera"
View
4 split screen _ Default camera setting (p. 31)
9 split screen
[] Press to exit from
a menu screen
EXiT
y RETURN
@
Single screen Navigation area
[] Press to return
to the previous
screen
RETURN
® A number of VIERA-compatibie network cameras can be found at the following sites:
http://www.panasonic.com/
http:llpanasonic.netlpcclproductslnetwkcaml
® For more details on setting and operation of the Network camera, please also read
the operating manuals for the Network camera.
Before using a Network camera, you need to register the camera as shown below. You can also
set default camera or disconnect/delete the registered cameras.
Follow direction _-_ in "Network settings" (p.44)
Select "Setup" and "Network cameras list"
If there is no registered camera
Select "Yes" to start search
Set Network camera setting
[] Press to exit from
a menu screen
EXiT
[] Press to return
to the previous
screen
RETURN
[] Network camera setting operation
"Please refer tocamera's settings andenable its link mode. Start searchingfor network camera?'_
_ "Yes" to start camera search.
_#Before you start to search for a camera, switch the camera to registration
mode. (For this operation, please refer to the operating manual for the
Network camera.)
_ Search condition also depends on "Network settings" (p.44-47).
"Remove camera information?"
_,_"Yes" to delete camera information.
"Disconnect to camera?"
_® "Yes" to delete camera connection.
"Disconnected" will be displayed in "Status".
"Set this camera as default camera?"
_ "Yes" to set to the default use.
Displayed "(Default)" next to camera name.
(Available only when reconnecting)
Q "Connect to Camera?
_® "Yes": "Connect" will be displayed in "Status".
(Attach up to 8 Network cameras simultaneously).
31
®
Z
©
©
B
To Next Page
Loading...
