SD
CARD
8
Identifying Controls
TV
Power LED
Standby: red●
On: green
When using the remote control, indicates the TV has received a command.●
Changes the input mode
Function select
Volume / Contrast / Brightness / Colour / ●
Sharpness / Tint (NTSC mode) / Bass / Treble /
Balance / Auto Setup (p. 34 and p. 35)
Mains power On / Off switch
Switch On to turn on the TV or turn the TV to standby ●
mode by the remote control
Remote control signal receiver
Do not place any objects between the TV remote control signal receiver and ●
remote control.
Timer LED
Active for Timer Programming or ●
Standby for Direct TV Recording: orange (flash)
Timer Programming On: orange
C.A.T.S. (Contrast Automatic Tracking System) sensor
Senses brightness to adjust picture quality when “Eco Mode” in the Picture Menu ●
is set to “On” (p. 30)
SD Card slot
(p. 50)
CI slot (p. 45)
Headphones
jack
(p. 61)
Using the clamper
To tighten:
Keep the
knob pressed
Rear of the TV
To loosen:
Do not bundle the RF cable and mains lead together (could cause distorted image).●
Fix cables with clampers as necessary.●
When using the optional accessory, follow the option’s assembly manual to fix cables.●
Accessories / Options
Increases or decreases the channel
position by one. When a function is
already displayed, press to increase or
decrease the selected function.
When in Standby mode, switches TV On.
To Next Page
Loading...
