Identifying Controls
Quick Start Guide
10
Indicator / Control panel
Using the On Screen Displays - Operation guide
Many features available on this TV can be accessed via the On Screen Display menu.
Operation guide
The On Screen Operation guide will help you to
operate the TV by using the remote control.
Example : [Owner ID]
Operation guide
0 9
* * * *
Owner ID
Please enter new PIN
PIN
EXIT
RETURN
PIN entry
How to use remote control
Open the main menu
Move the cursor / select from a range of options /
select the menu item (up and down only) / adjust
levels (left and right only)
Access the menu / store settings after adjustments
have been made or options have been set
Return to the previous menu
Exit the menu system and return to the normal
viewing screen
Auto power standby function
The TV will automatically go to Standby mode in the following conditions :
•
no signal is received and no operation is performed for 30 minutes in Analogue TV mode
•
[Off Timer] is active in the Setup Menu (p. 18)
•
no operation is performed for the period selected in [Auto Standby] (p. 34)
This function does not affect the recording of Timer Programming and Direct TV Recording.
1
Function select
[Volume] / [Contrast] / [Brightness] / [Colour] /
[Sharpness] / [Tint] (NTSC signal) / [Bass]
/
[Treble]
/ [Balance] / [Auto Setup] (p. 30, 31, 33)
[Music] or [Speech] mode in the Sound Menu
2
Channel Up / Down, Value change (when using the
F button), Switching the TV on (press either button
for about 1 second when in Standby mode)
3
Changes the input mode
When pressing the control panel button (1 - 3), the
control panel guide appears on the right side of the
screen for 3 seconds to highlight the pressed button.
4
Mains power On / Off switch
Use to switch the mains power.
If you turned the TV off into Standby mode by
using the remote control last time, the TV will be
in Standby mode when you turn the TV on using
Mains power On / Off switch.
5
Remote control signal receiver
Do not place any objects between the TV remote
control signal receiver and remote control.
6
C.A.T.S. (Contrast Automatic Tracking System)
sensor
Senses brightness to adjust picture quality when
[C.A.T.S.] in the Picture Menu is set to [On].
(p. 30)
7
Power and Timer LED
Red: Standby
Green: On
Orange: Timer Programming On
Orange (flash):
Recording of Timer Programming or Direct TV
Recording in progress
Red with orange flash:
Standby with Timer Programming On or Direct
TV Recording
The LED blinks when the TV receives a command
from the remote control.
567
Rear side of the TV
3
1
4
2
To Next Page
Loading...
