Using Common Interface
50
Using Common Interface
The Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.
This TV works only for Pay TV modules complying with CI standard.
This function is not available for BskyB’s Sky channels.
Video and audio signals may not be output depending on broadcasts or services.
Caution
Turn Off Mains power On / Off switch whenever
inserting or removing the CI module.
If a viewing card and a card reader come as a
set, first insert the card reader, then insert the
viewing card into the card reader.
Insert the module in the correct direction.
Remove the CI module from the TV when placing
the TV facing upward. Otherwise this may cause
damage to the CI module and CI slot.
Rear of the TV
Insert or remove completely
CI slot
CI module
Insert the CI module (optional)
The features that appear on screen are dependent on the contents of the selected CI module.
Follow the instructions that came with the viewing card to tune in the encrypted channels. If encrypted channels do
not appear, follow the steps below to verify that the card is recognised by the TV.
For more details, see the manual of the CI module, or check with the broadcaster.
1
Select DVB
(p. 16)
TV
2
Display the menu and select [Setup]
Main Menu
Picture
Sound
Setup
select
access
3
Select [System Menu]
System Menu Access
Setup Menu
select
access
4
Select [Common Interface]
System Menu
Shipping Condition
System Update
Software Licence
System Information
Common Interface
Owner ID
Access
access
select
5
Access Common Interface and follow the on-screen instructions
Common Interface
Slot 1:
Module inserted
On-screen instructions may not correspond to the remote control buttons.
To Next Page
Loading...
