FAQs | On screen messages
78
Problem Actions
Other
The LCD panel moves
slightly when it is
pushed with a finger
Clattered sound might
be heard
There is some flexibility around the panel to prevent damage to the panel.
The panel might move slightly when it is pushed with a finger, and clattered sound
might be heard. This is not a malfunction.
Overcurrent error
message appears
The connected USB device might cause this error. Remove the device and turn the
TV off with Mains power On / Off switch, then turn it on again.
Check foreign objects are not inside the USB port.
An error message
appears
Follow the message’s instructions.
If the problem persists, contact your local Panasonic dealer or the authorised
Service Centre.
On screen messages
Message Meaning / Action
All tuning data will be erased
[Shipping Condition] will erase all tuning data (p. 48)
Are you sure ?
Confirm correct operation.
Are you sure you want to
delete this timer ?
Press OK to delete timer.
Press RETURN to return.
Confirm correct operation.
Bad signal
The signal is weak. Check the aerial is plugged in properly. It may be
necessary to have an aerial installer check the signal and aerial alignment.
Reset channels. (p. 38)
Child Lock is active!
Press OK to enter PIN.
The selected channel is locked in Child Lock (p. 45). You must enter the PIN
number before the channel will be displayed.
Feature not available.
It is not possible to record from COMPONENT or HDMI. Connect the recorder
to the TV using a fully wired SCART cable for recording from the TV tuner.
Confirm Q-Link or VIERA Link settings (p. 60 - 63)
Feature not available.
Press OK to view how it works.
The selected feature on VIERA TOOLS is not available. Press the OK button
to view the demonstration to explain how to use it.
Found new software version
.
Press OK to start update (may
take over 40 mins) or press
EXIT to ignore and you can
update when TV is in standby
There is a new software available.
Invalid operation - Please
check settings and
connections.
Check the Q-Link or VIERA Link connection and setting (p. 60 - 63)
Invalid system time. Please
exit !
Cannot get the time information and cannot edit Timer Programming screen.
Check the connection of the RF cable.
Invalid system time, Timer
Programming will not work.
Please press TV button on
remote control and check time
display on Banner
Cannot get the time information. If there is no time displayed on the
Information banner, check the connection of the RF cable.
Max. number of timers already
set !
The maximum number of timer programming events is 15.
New channels found!
Press OK to update channel
list.
Press EXIT to ignore.
There may be new channels available.
This message will appear each time a change is made by the broadcasters.
This message can be deactivated by setting [New Channel Message] to Off in
[DVB Tuning Menu].
Selecting OK will perform [Update Channel List].
To Next Page
Loading...
