C
Christopher Barnett DDSSep 2, 2025
Why does Panasonic WH-ADC0916G9E8 Heat Pump operation start automatically when the timer is not set?
- KKevin SmithSep 2, 2025
The operation starts automatically because the sterilisation timer has been set.
To Next PageTo Next PageWhy does Panasonic WH-ADC0916G9E8 Heat Pump operation start automatically when the timer is not set?
The operation starts automatically because the sterilisation timer has been set.
Why does Panasonic Heat Pump make a loud refrigerant noise for a few minutes?
The loud noise is caused by protection control during deice operation when the outdoor temperature is lower than -10°C.
Why does Panasonic Heat Pump backup heater turn on automatically when it is disabled?
The backup heater turns on automatically due to the protection control of the indoor unit heat exchanger.
Why does steam come out of the Panasonic Heat Pump outdoor unit in the heating mode?
The steam is caused by the defrost operation in the heat exchanger.
Why does my Panasonic WH-ADC0916G9E8 system not heat up instantly?
If the system starts operating at a cold water temperature, it will take some time to heat up the water.
Why is cool mode unavailable on my Panasonic Heat Pump?
The system might be locked to operate in HEAT mode only, making the cool mode unavailable.
Why Panasonic WH-ADC0916G9E8 outdoor unit does not operate?
The outdoor unit might not operate due to the system's protection control when the outdoor temperature is outside the operating range.
Why doesn't my Panasonic WH-ADC0916G9E8 system heat up instantly?
The Panasonic Heat Pump system will take some time to heat up the water if it starts operating at a cold water temperature.
Why does my Panasonic WH-ADC0916G9E8 system switch off?
The system switches off because of the protection control. When the water inlet temperature drops below 10 °C, the compressor stops, and the backup heater turns on.
Why is there a delay after restarting my Panasonic Heat Pump?
General