What to check for Outdoor Direct Current (DC) peak detection in Panasonic Heat Pump?
If your Panasonic Heat Pump is experiencing Outdoor Direct Current (DC) peak detection, check the outdoor PCB and the compressor.
Why my Panasonic Heat Pump system cannot get warm instantly?
Due to the nature of the heatpump system, it may take some time to heat-up the water if the unit is operated from cold-start.
What causes total running current protection in a Panasonic Heat Pump?
If your Panasonic Heat Pump is experiencing total running current protection, it may be due to excess refrigerant. You should check the outdoor PCB.
What to check if my Panasonic Heat Pump shows indoor heat exchanger freeze prevention?
If your Panasonic Heat Pump is showing indoor heat exchanger freeze prevention, check the indoor heat exchanger and ensure there is no refrigerant shortage.
What to do if my Panasonic Heat Pump has a refrigeration cycle abnormality?
If your Panasonic Heat Pump has a refrigeration cycle abnormality, check for insufficient refrigerant, the outdoor PCB, and whether the compressor has low compression.
How do I troubleshoot an outdoor fan motor lock abnormality on my Panasonic WH-MDF06D3E5 Heat Pump?
If your Panasonic Heat Pump displays an outdoor fan motor lock abnormality, check the outdoor PCB and the outdoor fan motor.
What to do if my Panasonic Heat Pump shows outdoor defrost sensor abnormality?
If your Panasonic Heat Pump is showing an outdoor defrost sensor abnormality, you should check the outdoor defrost sensor.
What to do if my Panasonic Heat Pump has a pressure switch abnormality?
If your Panasonic Heat Pump has a pressure switch abnormality, check the pressure switch.
What to do if my Panasonic Heat Pump is showing a back-up heater OLP abnormality?
If your Panasonic Heat Pump displays a back-up heater OLP abnormality, you should check the back-up heater OLP. This may continue for 60 seconds.
What to do if my Panasonic Heat Pump displays an outdoor heat exchanger temperature sensor abnormality?
If your Panasonic Heat Pump is showing an outdoor heat exchanger temperature sensor abnormality, you should check the outdoor heat exchanger temperature sensor.
General| Heating Capacity | 6.0 kW |
|---|---|
| Energy Efficiency Class (Heating) | A++ |
| Energy Efficiency Class (Cooling) | A+ |
| Refrigerant | R32 |
| Type | Air to Water Heat Pump |
| Power Supply | 230V / 50Hz |
| Operating Temperature Range (Heating) | -15 to +24 °C |
| Operating Temperature Range (Cooling) | +10 to +43 °C |
To Next Page
