17
Installation of camera
Turn off the power of all related devices before installation.
1 Remove the dome cover.
2 Connect all cables.
If necessary, bind the cable with cable tie (locally procured).
3 Install the camera (The illustration below shows installation using a gang junction box (locally
procured) ).
Mount the camera with 2 screws (M4, locally procured).
Important:
• Be sure to avoid twisting the cables when tightening the screws.
Note:
• When attached to the ceiling:
Install the camera with its front (Model number indication face) facing the direction opposite to
the “
TOP” arrow of the installation mark (“ FRONT” direction of the installation template label
in the accessories).
• When attached to the wall:
Install the camera with the “
TOP” arrow of the installation mark facing upward.
Installation
Screws
(M4, locally procured)
Installation
mark
To Next Page
Loading...
