Panasonic WV-CM1430 - System Connections; Single monitor Connection; Multiple Monitor Connection; Audio circuit signal

-5-
SYSTEM CONNECTIONS
1. Single monitor Connection
• Connect the Video Output terminal of the camera or
VTR to the Video Input Connector (15) or (19) of the
monitor with 75-ohm coaxial cable.
2. Multiple Monitor Connection
• Connect the Video Output terminal of the camera or
VTR to the Video Input Connector (15) or (19) of the
video monitor with 75-ohm coaxial cable.
• Connect the Video Output Connector (16) or (20) on
the first monitor to the Video Input Connector (15) or
(19) on the second monitor with 75-ohm coaxial cable,
and continue until all monitors are connected.
Note: Properly check the connections in the input and
output, because the monitor will not be properly
terminated if the connections are wrong.
3. Audio circuit signal
• Connect the Video Out Terminal of VTR or camera to
the Video Input Connector (15) or (19) of this monitor
with 75-ohm coaxial cable.
• Connect the Audio Out Terminal of VTR to the Audio
Input Connector (17) or (21) of this monitor and con-
nect the Audio Input Terminal of the audio amplifier to
the Audio Output Connector (18) or (22) of this monitor
with a audio cable.
FOCUS
OUT
VIDEO
IN
AUDIO
IN
INPUT B
OUT OUT
VIDEO
IN
AUDIO
IN
INPUT A
OUT
FOCUS
OUT
VIDEO
IN
AUDIO
IN
INPUT B
OUT OUT
VIDEO
IN
AUDIO
IN
INPUT A
OUT
FOCUS
OUT
VIDEO
IN
AUDIO
IN
INPUT B
OUT OUT
VIDEO
IN
AUDIO
IN
INPUT A
OUT
FOCUS
OUT
VIDEO
IN
AUDIO
IN
INPUT B
OUT OUT
VIDEO
IN
AUDIO
IN
INPUT A
OUT
VIDEO OUT
Camera
Coax.
Cable
Coax.
Cable
VIDEO
OUT
Coax.
Cable
Coax.
Cable
VIDEO
OUT
VTR/Video Disc Player
Camera
Speaker
Amp
VIDEO
OUT
AUDIO
OUT
Camera