24
Step 2
Select a number (1 to 16) with which a pixel compensation point is registered and press the [SET] button.
→
The pixel compensation positioning screen appears.
Step 3
Press the [UP], [DOWN], [RIGHT], and [LEFT] buttons to move the crosshair cursor to the center of the flaw to be corrected and press
the [SET] button.
→ The flaw is corrected and the pixel compensation point is registered. The “PIX OFF” screen appears again. An asterisk “*” is
attached at the right side of the number when registration is completed. The coordinate is expressed in figures.
Note:
•Tocleartheregisteredpixelcompensationpoint,movethecursorto“1”oftherightof“DEL”,usethe[RIGHT] and [LEFT] buttons
to select the number with which the target pixel compensation point is registered and press the [SET] button. The registered pixel
compensation point is cleared, and an asterisk “*” at the right side of the number disappears.
22. Communication setting [COMMUNICATION]
The required communication configuration is performed to use this unit integrated into the system with a receiver.
COAX (RCV): When using our receiver (e.g. WV-RC150).
COAX (default): When not using any receiver.
23. Default resetting [CAMERA RESET]
The settings in the setup menu are restored to the default settings.
Move the cursor to “
→
PUSH SET” of “CAMERA RESET” and hold down the [SET] button for more than 2 seconds to enter the
“RESET?” screen.
To return to the previous screen without resetting, move the cursor to “NO” and press the [SET] button. To restore the default
settings, move the cursor to “YES” and press the [SET] button.
Note:
•Thedataoftheregisteredpixelcompensationpointsisnotcleared.
•Tosetwhethertoresetthecamera,select“YES”or“NO”byusingthe[SET]button.Tosetwithacontroller,refertotheinstruc-
tion manual of the controller.
24. Serial number viewing [SER.NO.]
Displays the serial number of this product.
To Next Page
Loading...
