31
Communication setting [COMMUNICATION]
The required communication configuration is performed to use this unit integrated into the system with a receiver.
COAX (RCV): Select COAX (RCV) when using our receiver (e.g. WV-RC100 or WV-RC150).
COAX (default): Does not use any receiver.
Default resetting [CAMERA RESET]
The settings in the setup menu are restored to the default settings.
The default settings are restored by moving the cursor to "PUSH SW" of "CAMERA RESET" and holding down the right, left, and
setting buttons for more than 2 seconds simultaneously.
Note:
• Thedataoftheback focus setting and registered pixel compensation points is not cleared.
Serial number viewing [SER.NO.]
The serial number of this unit appears.
To Next Page
Loading...
