Panduit PANTHER LS8E User Manual

INTRODUCTION & SAFE OPERATION
5
Do Not Substitute Parts Or Modify Equipment
Because of the danger of introducing additional hazards, do not install substitute
parts or perform an unauthorized modification to the printer or its accessories. The
proper components for service and repair may be obtained from Panduit Corp.
WARNING
:
When the printer has been in use for an extended period of time, the printer
motor may become hot. DO NOT touch the printer motor with bare hands.
Information to USA Users
NOTE: This printer has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of FCC rules. These limits are designed to
provide reasonable protection against harmful interference when the printer is
operated in a commercial environment. This printer generates, uses, and can
radiate radio frequency energy and, if not used in accordance with this instruction
manual, may cause harmful interference to radio communications. Operation of
this printer in a residential area is likely to cause interference in which case the
user will be required to correct the interference at his own expense.
Information to Canadian Users
This digital apparatus does not exceed Class A limits for radio noise emissions for
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depassant
les limites applicables aux appareils numeriques de la class A prescrites dans le
Reglement sur le brouillage radioelectrique edicte par le ministere des
Communications du Canada.
It is possible that infrequent electrical phenomena (static discharge, power line
fluctuations) may cause printer function to be temporarily interrupted. In this case,
the printer will usually reset itself. In extreme cases, the user should remove then
re-apply power (batteries or AC adapter).

Panduit PANTHER LS8E Specifications

Printing Specifications

print method	Thermal transfer
effective print width	1.00” (25.4 mm)
print length	12.00” (maximum label length)
print resolution	203 dpi (horizontally and vertically)
label width	0.24” to 1.0”
media length	Up to 25’ continuous tapes

Display

display	4 line x 14 graphic LCD with backlight
lcd contrast control	Adjustable via keypad

Power

power supply	6 AA alkaline batteries
ac adapter	Universal Input (100 - 240 VAC, 50/60 Hz)

Operating Environment

operating temperature	41-104° F (5-40 °C)
operating humidity	0 - 90% relative humidity (non-condensing)
storage temperature	-40-140° F (-40-60 °C)
storage humidity	0 - 90% relative humidity (non-condensing)

Weight and Dimensions

weight	1.76 lbs. (0.80 kg)