2
Flex, fan, and align the paper edges before loading.
3
Load the paper stack with the printable side faceup.
Notes:
•
Load letterhead faceup with the header toward the back
of the tray for one
‑
sided printing.
•
Load letterhead facedown with the header toward the
front of the tray for two
‑
sided printing.
•
Do not slide paper into the tray.
•
To avoid paper jams, make sure that the stack height is
below the maximum paper fill indicator.
4
Adjust the guides to match the size of the paper that you are
loading.
5
Insert the tray.
If necessary, set the paper size and paper type from the control
panel to match the paper loaded.
Loading the manual feeder
1
Adjust the guide to match the size of the paper that you are
loading.
2
Load a sheet of paper with the printable side faceup.
•
Load letterhead with the printable side faceup and the top
edge entering the printer first for one
‑
sided printing.
5
To Next Page
Loading...
Need help?
General
