Ê
5 -9
4. The following aspects should be inspected if the printer has problems while they are
used in network:
• Inspect if the rewall software blocks communication. If the computer and printer ar
connected in the same network but they cannot be searched, the communication might be
blocked by rewall software. Please refer to the user guide of rewall software to turn rewall
off and then try to search the printer again.
• Inspect if the I address assignment of printer is correct. You can inspect IP address by
printing the network setup information page of printer out.
Note: • Please refer to the user guide or consult the manufacturer for information related
to access point (wireless router).
• Please refer to the following steps to check if printer and computer are in the same network:
1) Select "Command prompt" as shown below.
a. Windows 8/10 system：Select "Search" button in the Start Menu and input "Command
prompt"in search bar，then press the "Enter”button in the keyboard.
b. Windows 7/Vista/XP system：click "Start" menu-"All procedures"-"Attachment"-"Command
prompt ".
2) Input ping and your printer IP address in popup window, and press "Enter" button.
For example: ping XXX.XXX.XXX.XXX(“XXX.XXX.XXX.XXX” is printer IP address)
3) If RTT is indicated in the window, that is to say your printer and computer are in the same
network.If RTT is not indicated in the window, please refer to Chapter 5 to re-configure the
printer wireless network.
To Next Page
Loading...
Need help?
General
