II
Safety Information
Please read the following safety warnings carefully and make sure you understand
them before starting maintenance procedures.
Important Precautions
To avoid the possible risk of damage to the product, it is strongly recommended
that maintenance be carried out by trained technicians from Pantum, rather than
untrained personnel. User must bear the responsibility for any personal injury or
product damage occurring during maintenance of the product and the
components specified in this manual. Therefore, you must read this manual
carefully before performing the maintenance in order to carry out correct operation
and maintenance of this product.
Please keep this manual for future maintenance purposes.
Instructions for warnings, cautions, and notes:
* To avoid personal injury, please pay attention to all warnings.
* To maintain the printer properly and avoid damage, please follow the warnings.
* Please note the relevant prompts while maintaining the printer.
* Warnings listed in this manual are as follows:
There is high-voltage electrode inside the printer. Before
cleaning the printer, make sure the power is turned off!
Plugging and unplugging the power cord plug with a
wet hand can result in an electric shock.
The fuser unit is attached with a high temperature
warning label. Please do not remove or damage
this label.
The fuser unit is hot when and after
printing. Touching the fuser unit (the
shaded area as shown) may cause burns!
Warning
To Next Page
Loading...
Need help?
General
