Pantum P3300 SERIES User Manual

50
If the connection is not established after more than 2min, the printer will return to its ready state, the
Wi-Fi indicator will be off and Wi-Fi Protected Setup (WPS) connection will fail. If it is needed to
connect again, please repeat steps 3-4 above.
Note：
• Please refer to Chapter 1.5 for how to cancel and disconnect Wi-Fi connection.
• After successful Wi-Fi Protected Setup (WPS) connection, please install a driver if
you want to print via wireless network.
5.1.3. How to disable the Wi-Fi network connected
Connect the wireless network in infrastructure mode by the steps above. If connected, the Wi-Fi
light on the control panel is normally on. Press and hold this button for more than 2s to disconnect
from Wi-Fi network (Wi-Fi light will be off).
5.2. Wi-Fi Direct mode
You can connect wireless client (including the computer and mobile device with wireless network
feature) to wireless network printer without using the access point (wireless router).
5.2.1. Preliminary preparations
1. Printer with the Wi-Fi Direct feature.
2. Wireless client (including computer and mobile device with wireless network feature).
5.2.2. Wi-Fi Direct connection
Before connecting to printer hotspot, turn on direct Wi-Fi connection of the printer by short pressing
"Wi-Fi" button on the panel.
Note：
• Short press "Wi-Fi" button on the printer panel to automatically print out "Mobile
Device Wi-Fi Connection Wizard" page for Wi-Fi connection by mobile devices.

Pantum P3300 SERIES Specifications

General

Print Technology	Laser
Print Resolution	1200 x 1200 dpi
Connectivity	USB 2.0
Media Types	Plain, Thick, Thin, Transparency, Cardstock, Label
Media Sizes	A4, A5, A6, B5, Letter, Legal, Executive, Envelope (DL, C5, B5)
Operating Systems Compatibility	Windows, Linux, Mac OS
Media Weight	60 - 163 g/m²