TELEPHONE AND ACCOUNT NUMBERS:
(default empty)
[TRBL] must end the phone number if less than 16 digits are programmed.
Special instructions can be entered in the telephone numbers using the following keys:
[10] = the number "0"
[11] =
*
[12] = #
[BYP] = switch from pulse to tone while dialing
[MEM] = pause 4 seconds
[TRBL] = end of number
Streamlined (section) programming = [ENTER] + installer + [2], [7]
COMPUTER TELEPHONE NUMBER: (View at addresses 060 to 067.)
00 __ / __ / __ / __ / __ / __ / __ / __ 01 __ / __ / __ / __ / __ / __ / __ / __
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
CENTRAL STATION TELEPHONE NUMBER 1: (View at addresses 068 to 075.)
02 __ / __ / __ / __ / __ / __ / __ / __ 03 __ / __ / __ / __ / __ / __ / __ / __
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
CENTRAL STATION TELEPHONE NUMBER 2: (View at addresses 076 to 083.)
04 __ / __ / __ / __ / __ / __ / __ / __ 05 __ / __ / __ / __ / __ / __ / __ / __
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
ACCOUNT "A" AND "B": (View at addresses 084 to 087.)
06 __ / __ / __ / __ __ / __ / __ / __
1 2 3 4 5 6 7 8
A B
If only one account number is required, the same number must be entered for both account "A" and "B".
- 2 -
(Used to program sections 00 to 34)
To begin programming
Press [
ENTER
] + installer code + [2] [7]. ([
ENTER
] and [2
ND
] keys will flash)
Enter 2 digit section number for programming (00 - 34) ([
ENTER
] key is "steady" and [2
ND
] key is "off")
Enter 8 digit to program the section. Keypad will beep verifying completion of section programming. Data is saved and the next
section is advanced to automatically for programming.
To select a specific section press [
CLEAR
] or [
ENTER
]. ([
ENTER
] and [2
ND
] keys will flash).
Enter 2 digit section number (00-34) ([
ENTER
] key is "steady" and [2
ND
] key is "off").
To exit programming mode press [
CLEAR
].
PG728
Press [TRBL] to end the
phone number if less than
16 digits are programmed.
Press [TRBL] to end the
phone number if less than
16 digits are programmed.
Press [TRBL] to end the
phone number if less than
16 digits are programmed.
For 3 digit account number,
enter "skip" ([2ND]) as first
digit.
If only one central station phone number is used, the same number must be programmed
for telephone number 1 and 2.
To Next Page
Loading...
Need help?
General
