Need help?Do you have a question about the Paradox Digigard DG85 and is the answer not in the manual?
General| Operating Voltage | 9-16 Vdc |
|---|---|
| Tamper Protection | Yes |
| Mounting Height | 2.1 m to 2.7 m (7 ft to 9 ft) |
| Type | Outdoor Motion Detector |
| Detection Technology | Passive Infrared |
| Detection Method | Motion Detection |
| Detection Range | 11m (35ft) |
| Power Source | Wired |
| Operating Temperature | -35°C to +50°C (-31°F to +122°F) |
| Humidity | 95% RH (non-condensing) |
| Pet Immunity | Up to 40 kg (90 lbs) |
| Compatibility | Compatible with Paradox alarm systems |
Adjusting the detector's PCB height for optimal performance and coverage matching installation height.
Selecting between DGP2 Mode for advanced communication or Relay Mode for standard detector function via DIP switches.
Determines DSP for false alarm rejection based on environment, choosing between single or dual edge detection.
Enables or disables the detector's LED indicator, which illuminates for movement signals that reach alarm thresholds.
LED flashes once for movement signals kept in memory but not triggering an alarm, indicating recorded events.
Activates tamper detection, sending a message to the control panel when the anti-tamper switch is open.
Adjusting the detector's sensitivity level from 0 (lowest) to 10 (highest) for optimal detection range.
Procedure to verify detection coverage by walking through the protected area at various sensitivity settings.
To Next Page
