4 Digigard DG85
an LCD keypad: For section numbers refer to
the detector settings on the back cover.
1. Press and hold the [0] key.
2. Enter your [
INSTALLER CODE].
3. Enter section [953] (DGP-848) / [4003]
(DGP-NE96).
4. Enter the detector’s 8-digit [
SERIAL NUMBER]
(located on PCB cover).
5. Enter the 3-digit [
SECTION] you wish to
program.
6. Turn the desired option on/off or key in the
required data.
The detector keeps the last settings in
memory even after it has been powered
down, regardless of whether its settings
were modified via Module Programming
Mode or the DIP switches and trim pot.
Single or Dual Edge Processing
This option determines the DSP (Digital Signal
Processing) of the detector. Single Edge
Processing should be used in normal
environments with minimal sources of
interference. Dual Edge Processing provides
better false alarm rejection if the detector is
placed near sources of interference that can
adversely affect it. Refer to the table on the back
cover.
LED Setting
This option enables or disables the LED. The
LED illuminates for 5 seconds when the unit
detects a movement signal that reaches the
DG85_TI04.fm Page 4 Tuesday, February 15, 2005 9:17 AM
To Next Page
Loading...
Need help?
General
